Tips-A2Z home page


Sub-categories

(None)

All  |   Discussion (0)Air compressor

General usage tips:
    — Ensure it is always filled with the correct amount and type of engine oil.

    — Do not use with an extension cord. Plug directly into the power source.

    — If powering a framing gun, the nail depth can be adjusted via the air regulator.

    — Always check the air valve for clogging before each use, by pulling it a few times.

    — At the end of each use, release air via the pull-ring air valve down to 1.5 bar. This pressure should be safe enough to release the air hose. Wear gloves to protect one's skin from the freezing air temperature.

    — Always open the tank drainage screw at the end of every use, to allow moisture to drain away.

    — Before starting the air compressor, connect the hose and appliance.

    — Adjust the regulator to run at the lowest workable pressure, to save power.

   kellyjones00 (593)

– –– ——— –– –

 

 

To post a new tip, sign up for a free account.
(Unfortunately this is a necessary spam prevention measure)
Who is online
In total there are 43 users online :: 0 registered and 43 guests (based on users active over the past 5 minutes)